Entry type: FAQ, Entry ID: 35014199, Entry date: 04/04/2016
(0)
Rate

SINAMICS G120/G120D: Template for Acceptance test and certificate for safety application

  • Entry
  • Associated product(s)
The machine manufacturer must carry out an acceptance test of the selected Safety Integrated functions (SI functions) on the machine. During the acceptance test all the limit values entered for the enabled SI functions must be exceeded to check and verify that the functions are working properly.

Where do I find a template for my Acceptance test and certificate for my safety SIMATIC ET200x FC application?

Please find attached the document for acceptance- test and certificate for SINAMICS G120 respectively for SINAMICS G120D.

 Registrierung notwendig  safety_acceptance_test_report_sinamics_g120_en_v_1.doc (334,5 KB)

 Registrierung notwendig  safety_acceptance_test_report_sinamics_g120d_en.doc (304,0 KB)

Note

The acceptance test must only be carried out after the safety functions have been commissioned.

This FAQ applies only to the SINAMICS G120/G120D Control Units without “-2” in the product name.

Acceptance tests and certificates for SIMATIC ET 200x FC please find under Entry-ID: 35001360