Entry type: FAQ, Entry ID: 35014199, Entry date: 09/11/2013
(0)
Rate

SINAMICS G120 (CU2x0x): Where do I find a template for my Acceptance test and certificate for my safety SINAMCIS G120 / G120D application?

  • Entry
  • Associated product(s)

This FAQ applies only to the SINAMICS G120/G120D Control Units without “-2” in the product name.

The machine manufacturer must carry out an acceptance test of the selected Safety Integrated functions (SI functions) on the machine.
During the acceptance test all the limit values entered for the enabled SI functions must be exceeded to check and verify that the functions are working properly.

Note:
The acceptance test must only be carried out after the safety functions have been commissioned.

Please find attached the document for acceptance- test and certificate for SINAMICS G120 respectively for SINAMICS G120D.

Content of Downloads Download
Safety Acceptance Test Report SINAMICS G120 ( 334 KB )
Safety Acceptance Test Report SINAMICS G120D ( 304 KB )

 

Below you will find more information about distributed SIMATIC ET 200x FC:

  • FAQ: "Where do I find a template for my Acceptance test and certificate for my safety SIMATIC ET200x FC application?"; Entry-ID: 35001360