Entry type: FAQ, Entry ID: 7878468, Entry date: 01/10/2002

Configuring headers of OP3 pictures in ProTool V5.2 /SP2

  • Entry
  • Associated product(s)

How can I assign headers to OP3 pictures so that the pictures are listed in the table of contents?

In ProTool V5.2 / SP2 you can no longer assign headers to OP3 pictures. If you still want to assign a header to a picture so that it is displayed in the table of contents, then please proceed as follows:
Configure an empty picture for an OP7 and give this picture a header. Then copy it into an OP3 project. Now you can no longer change the header.

With ProTool V6, headers can be assigned.

Panels, Overview