Monitoring 24V load circuits using SITOP PSE200U with single channel message and SIMOTION CPU
Using the SITOP PSE200U selectivity module with single channel message enables you to monitor up to four 24V load circuits for overload or short-circuit. The signal at the state output (S) of the SITOP PSE200U module provides you with serially coded information on the state of the individual load circuits connected to outputs OUT 1 to OUT 4 of the SITOP PSE200U selectivity module. The state of the load circuits shall be detected by a SIMOTION CPU and monitored.
The entry on hand contains a function block as well as a function description. The function block enables you to read and evaluate the signal of the status output (S) via a digital input at the SIMOTION CPU. A possible application, for example, would be indicating this information as alarm message on a panel.
The figure below shows the graphic representation of the solution.
|Content of Downloads||
|Function block documentation
Description of the function block for SIMOTION SCOUT V4.3.1 and SIMOTION CPUs
ST source (ST = structured text) of the function block for SIMOTION SCOUT V4.3.1 and SIMOTION CPUs