Hi!

Just like so many other peaople my MB_CLIENT block is also stuck in status 7002. I read all of the posts in the forum but still here,

can pls someone help me?

I get same problem
I solved it with following settings:

#CONNECT.InterfaceId := "Local~Interface_PROFINET_1";        // or simply 64 for a PLC 1200
#CONNECT.ID := 1;
#CONNECT.ConnectionType := 11;
#CONNECT.ActiveEstablished := 0;
#CONNECT.RemoteAddress.ADDR[1] := 192;
#CONNECT.RemoteAddress.ADDR[2] := 168;
#CONNECT.RemoteAddress.ADDR[3] := 1;
#CONNECT.RemoteAddress.ADDR[4] := 10;
#CONNECT.RemotePort := 0;                                       // not working if 502
#CONNECT.LocalPort := 502;
 

SOLVED HERE:

I had the same problem and solved changing the version of the block from V5.2 to V5.0

Hello everyone,

I have faced a similar problem. I was trying to simulate MB Client and Server in PLCSim V15, I tested for CPU firmware 4.0. After setting all things right my server error status was 7002 and client error was 80C8. after checking all the values, I find that the problem was due to the optimized data block access. the MB data block I was using was selected optimized access. I just unchecked that now the connection is OK. 

Hope this might help... 

Hello sir,

Did you solve your problem ? Because I have exactly same things !

Thanks

New question published by AJBUCKY is split to a separate thread with the subject PLCsim: MBTCP with Server and client devices.

Best regards
Moderator_Lan