Hi,

it is necessary to replace the old controller with a new one. Do I need to change the HW configuration? Will the previous network configurations work? What to look for when replacing?

itSL

Hi,

it is necessary to replace the old controller with a new one. Do I need to change the HW configuration? Will the previous network configurations work? What to look for when replacing?

Dear itSL

Depending on the modified equipment (type, number, version of the replaced equipment and related connections), the same changes must be applied to the HW. After Save&Compile of HW Check Net Pro to see if changes have been saved or no?
If necessary, the required changes should be made according to the HW config in the NetPro environment.
At the end entire program should be Save&Compile and then download it to the controller/s.

best regards

Hello,

yes, you need to download HW  configuration, connections-NetPro and all software blocks.

Best Regards,

Šukrija Razić