Is it possible to continue the movement after using mc_halt?
Created by: ebsolon at: 6/2/2021 11:07 PM (2 Replies)
Rating 
Thanks 1
3 Entries
| 6/2/2021 11:07 PM | |
|
Posts: 10 Rating:
|
Is it possible to continue the movement after using mc_halt I want my system to continue the mouvement from fhe point where mc_halt was activated Anyway to deactivate it ------------------------------------------------------------------------------------------ |
Last edited by: Jen_Moderator at: 06/03/2021 08:50:35New subject after splitting |
|
| 6/2/2021 11:09 PM | |
|
Posts: 10 Rating:
|
Hey could use continue the mouvement after using mc_halt? Is it possible i have TP v15. 1 |
| 6/4/2021 2:21 PM | |
Joined: 10/11/2006 Last visit: 1/20/2026 Posts: 6071 Rating:
|
Hello, you can store the target position, and do an MC_MoveAbsolute after MC_Halt or you stopp the axis with Velocity Override = 0; <TO>.Velocity.Override 7.4 MC_Halt https://support.industry.siemens.com/cs/de/en/view/109781849 |
|
With best regards, |
|
This contribution was helpful to
|
|
Follow us on