SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

ob31 error regarding

2/14/2009 9:38 AM	Rate (0)
naga Posts: 101 Rating: (0)	Dear all, Recently I faced a problem with S5-135 PLC. While downloading from PG backup, an error message "OB 31 : Can't transfer PLC Sys. block!. occured. How to overcome this type of problems and normally when this type of error occurs?. What for OB31 is and can it be ignored and proceed for further downloading. The PLC is euipped with CPU 928 B. Pl. clarify. Regards, Naga
naga Posts: 101 Rating: (0)
Suggestion To thank Quote Answer

2/14/2009 10:04 AM	Rate (0)
IBN-Service Posts: 8946 Rating: (1000)	naga Dear all, Recently I faced a problem with S5-135 PLC. While downloading from PG backup, an error message "OB 31 : Can't transfer PLC Sys. block!. occured. How to overcome this type of problems and normally when this type of error occurs?. What for OB31 is and can it be ignored and proceed for further downloading. The PLC is euipped with CPU 928 B. Pl. clarify. Regards, Naga Hello, OB31 (setup scantime monitor) is not supported by CPU 928 B. The scantime monitor setting must be done by adjusting the DX0.
IBN-Service Posts: 8946 Rating: (1000)
Suggestion To thank Quote Answer

3/15/2009 9:00 AM	Rate (0)
naga Posts: 101 Rating: (0)	Dear all, Thank you for the reply. Could you pl. elaborate further how to adjust the scan time thro' DX0. Regards, Naga
naga Posts: 101 Rating: (0)
Suggestion To thank Quote Answer

3/15/2009 9:38 PM	Rate (0)
IBN-Service Posts: 8946 Rating: (1000)	naga Dear all, Thank you for the reply. Could you pl. elaborate further how to adjust the scan time thro' DX0. Regards, Naga select "edit DB-mask" (CTRL+F1) -> DX0 for 135U then you can adjust the scantime monitor (5th row).
IBN-Service Posts: 8946 Rating: (1000)
Suggestion To thank Quote Answer

3/18/2009 9:36 AM	Rate (0)
naga Posts: 101 Rating: (0)	Dear all, Thank you naga
naga Posts: 101 Rating: (0)
Suggestion To thank Quote Answer

3/18/2009 10:26 AM	Rate (0)
IBN-Service Posts: 8946 Rating: (1000)	naga Dear all, Thank you naga You are welcome.
IBN-Service Posts: 8946 Rating: (1000)
Suggestion To thank Quote Answer

Share this page:

Share this page on...