Hello .I have g120 p.n driver. I connect it to a small motor. and start it handily on my table in a laboratory to learn the driver.it run handily good .now I am trying to start it with 24 v throw the digital input.is it possible? If its possible wat parameter does I have to change to work with digital input? I work with the operation manual and I can't run the motor by the digital input. I work only with b.o.p no computer or software.thank you!

Control Sinamics G120 CU240E-2 by sending control commands directly to its port.

https://www.youtube.com/watch?v=fhs1027YPxU

Sinamics G120 CU240E-2 Status Word

https://www.youtube.com/watch?v=q7qfG7BwIE0
 

thank you very much!