salah47

 

PISCEAN 2010

 

salah47

[snip]

Is it possible to use an POS.ANGLE read position of an Incremental Encoder, or maybe I haven't understood very well this connector 

If it is possible, and we can use it in an incremental Encoder,  please explain why and tell me what parameter equivalent in Sinamics

Hello,

Please refer attached sheet (extracts from Masterdrive manual) according to manual any encoder with phase shift of 90 deg between 2 tracks can be used. So check value of p130 parameter of your masterdrive backup file. It must be 11, 12, 15 or 16. So incremental encoder can be configured to measure rotor angle position & not necessary that it should be absolute type.

In Sinamics G120, please check p0400 wherein connected encoder type is selected.

Hope this helps. 

 Thanks, This information is helpful for me 

 what is the parameter in case of s120 defining actual mechanical rotor angle ? We can get the value in connector kk0090 in case of masterdrive mc plus.

------------------------------------------------------------------------------------------
Split from Angle position parameter MASTERDRIVE in an incremental Encoder ??!.