hi guys 

i have one plc subnet in the range 10.13.180.x and my scada network in the range 192.168.55.x

i have a scalance s615 i am trying to set up as a router between subnets but I'm not sure i have the configuration right between vlans

any advice?

Hi Robbie,

Can you share what your exact configuration is right now?

As far as my understanding goes, connecting two different subnets to each other is usually achieved by setting the same default gateway to which the subnets are both connected.

Hope this helps :)

Hi :)

so on the web management i have 

vlan 

i.p address 192.168.55.1

subnet mask 255.255.255.0

vlan 2 i.p address 10.13.180.140

subnet mask: 255.255.255.0

default gateway : 10.13.180.140

in lab conditions i can ping vlan 2 from vlan 1, but not the other way around,

in tia i can also go online with devices in vlan 2 when im connect to vlan 1 

i'm going to install it today after production and see if i can display values from vlan 2 devices on my vlan 1 hmi

Hi,

I was wondering if you ever managed to resolve your issue with the S615?

If so could you post the solution as I seem to have a similar issue.

Thanks