Hi colleagues, I'm using a MTP1000 Unified Comfort V18.0.0.1.

The panel takes the time from the PLC (NTP Server)(UTC 0). But in the alarm viewer, the alarms appears with a different hour (UTC +1).

I would like that the alarms in the alarm viewer take the same time of the panel.

Thank you. 

the alarm control can use a different timezone, as set in "miscellaneous > time zone"

if this setting is -1 it should use the timezone set in the panel settings.

alanTI

the alarm control can use a different timezone, as set in "miscellaneous > time zone"

if this setting is -1 it should use the timezone set in the panel settings.

 Hi alanTI, thanks for your answer. The "Time zone" settings is already configured with "-1".