I have a same problem
I want to connect the SINAMICS DCM DRIVE from PC with PC Adapter USB A2 Cable
I changed the PROFIBUS address with the BOP20 Keypad
Set PG/PC interface correctly but i cant find the drive in the Accessible Nodes in SINAMICS STARTER Software
Anyone Help me about this 
Also have error 0x0313 in PG/PC Interface Diagnostics window when i test it?
I check the BAUD RATE and its showing 255 = Unknown
I reset the Parameters with the BOP20 Keypad but the drive is not ready, Its Ready LED Light is Blinking, is that the problem?
or the communication will happen anyway?
I once communicate this drive via PLC S7-300 with PROFIBUS Buss
Now i Cant communicate directly through Laptop with PC Adapter USB A2 Cable, Help me solve the problem Please?

------------------------------------------------------------------------------------------
Split from Upload program from Sinamics DCM with Siemens PC Adapter USB A2.

Fuadhimu

I have a same problem
I want to connect the SINAMICS DCM DRIVE from PC with PC Adapter USB A2 Cable
I changed the PROFIBUS address with the BOP20 Keypad
Set PG/PC interface correctly but i cant find the drive in the Accessible Nodes in SINAMICS STARTER Software
Anyone Help me about this 
Also have error 0x0313 in PG/PC Interface Diagnostics window when i test it?
I check the BAUD RATE and its showing 255 = Unknown
I reset the Parameters with the BOP20 Keypad but the drive is not ready, Its Ready LED Light is Blinking, is that the problem?
or the communication will happen anyway?
I once communicate this drive via PLC S7-300 with PROFIBUS Buss
Now i Cant communicate directly through Laptop with PC Adapter USB A2 Cable, Help me solve the problem Please?

Duplicate!

Existing also a own topic. 

Topic closed, because the question has been posted twice. The active topic can be found here:

Upload program from Sinamics DCM with Siemens PC Adapter USB A2 Cable

Kind regards, Moderator_Lan