I have a same problem
I want to connect the SINAMICS DCM DRIVE from PC with PC Adapter USB A2 Cable
I changed the PROFIBUS address with the BOP20 Keypad
Set PG/PC interface correctly but i cant find the drive in the Accessible Nodes in SINAMICS STARTER Software
Anyone Help me about this 
Also have error 0x0313 in PG/PC Interface Diagnostics window when i test it?
I check the BAUD RATE and its showing 255 = Unknown
I reset the Parameters with the BOP20 Keypad but the drive is not ready, Its Ready LED Light is Blinking, is that the problem?
or the communication will happen anyway?
I once communicate this drive via PLC S7-300 with PROFIBUS Buss
Now i Cant communicate directly through Laptop with PC Adapter USB A2 Cable, Help me solve the problem Please?

------------------------------------------------------------------------------------------
Split from Upload program from Sinamics DCM with Siemens PC Adapter USB A2.

I did but still there is no communication between PC and SINAMICS DCM Drive
I attached the screenshot of PG/PC interface

check all the transmission rate, still there is no progress

When did you reach out to your regional / local Siemens representative, distributor, and submit a new request for specific assistance using "Support Request" -> Create new request?

What have they suggested so far?

Fuadhimu

check all the transmission rate, still there is no progress