SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Output remaining on after stop

8/12/2009 5:23 PM	Rate (0)
danfenton Posts: 12 Rating: (0)	Hi, I've got a problem with an output which is still on when i go from run mode to stop to run again. I have attached an image to help explain my problem. It is the output LOP_Latch in network 18 of the program that does not reset itself. It is engergised by a normally open momentary push button (Start). Is there a way i can reset the output values when in stop mode? Thanks Dan Attachment problem1.JPG (206 Downloads)
danfenton Posts: 12 Rating: (0)
Suggestion To thank Quote Answer

8/14/2009 12:13 AM	Rate (0)
Tomy Master Platinum Member Joined: 5/4/2009 Last visit: 1/1/2026 Posts: 916 Rating: (40)	Dear Danfenton... Have you ever put that output in "Force" status? Have luck. Tomy the Master.
	Aim Higher
Suggestion To thank Quote Answer

8/14/2009 9:10 AM	Rate (0)
Arunakat1 Posts: 217 Rating: (52)	Hello, Do you using mb10, mw10, or md 10 in any ware in the program? If so that might be the problem. Best regards,
Arunakat1 Posts: 217 Rating: (52)
Suggestion To thank Quote Answer

8/14/2009 10:09 PM	Rate (0)
rosa Posts: 191 Rating: (58)	Hi!! you can reset your outputs at the first scan cycle of the PLC using SM0.1 ROSA
rosa Posts: 191 Rating: (58)
Suggestion To thank Quote Answer

8/17/2009 3:12 PM	Rate (0)
suri Posts: 23 Rating: (1)	i'm not that i understood correctly, but if your problem is that your program keeps a digital output ON even after after a run-to-stop transition, you should checkin System Block -> Output Tables to see that you don'thave a marked output in the table. Attachment system block.JPG (200 Downloads)
suri Posts: 23 Rating: (1)
Suggestion To thank Quote Answer

Share this page:

Share this page on...