Hi,

Check the symbol table weather you are using a same symbol which is used before, if so use another symbol, which is not used. If I understand correctly this may solve your problem.

Regards.

Hi,

I think I found the problem. You are using HSC0 and HSC3 but in this case I0.1 is overlapping for broth HSCs so you have to change for another HSC.

See the attachment.

Regards.

Hi,

Sorry for late reply as I was busy with a project last week.

Well I check with my own program using HSC0 and HSC3 in mode 12 but I didn’t find any difficulty with it, both hsc’s were working fine in mode 12. I get pulses for q0.0 and q0.1 using position control wizard.

Perhaps you should look back to your program again. If you also using position control wizard you can check it with out any program but only with hsc wizard and position control wizard. If it is ok then you can add your project to it.

Thanks your help Arunakat1 and sorry for the late reply, I haven'tvisitedthe forum since my last problem. The solution was simple, there wasno problem, the symbol table still shows HSC's as overlapped, but the program actually compiles and run without any problem, in fact the project is already running on production.

Regards