SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Serial connection with an OP77a, CM1241 and Winccflex help needed

1/27/2011 3:18 PM	Rate (0)
Jean-Francois Posts: 36 Rating: (0)	Hello I'am converting an S7-200 setup to S7-1200 so it is why i try to do it this way. (using serial interface on a PN CPUand Winccflexible because i had some parts availaible....) I'm looking to connect an OP77a hmi loaded with Winccflexible 2008 sp2 to an S7-1200. I added a 6ES7241 1CH30 module CM1241 RS485 module to my cpu but i couldn't find where i should set up the serial adressing of the module...I just found where we chosse speed and parity config and a place that say "ID 11" but i've tried to use node 11 unsuccessfull On the Winccflex side, i selected a S7300/400 connection but i'm not sure of which other setting i should use? Network profile and PLC adress etc... Any help would be much appreciated
Jean-Francois Posts: 36 Rating: (0)
Suggestion To thank Quote Answer

1/27/2011 5:23 PM	Rate (0)
Jean-Francois Posts: 36 Rating: (0)	Humm by the way is this suppose to be possible with the actual soft and hardware ?
Jean-Francois Posts: 36 Rating: (0)
Suggestion To thank Quote Answer

1/27/2011 7:34 PM	Rate (0)
0_Einstein Grandmaster Joined: 7/7/2010 Last visit: 12/31/2025 Posts: 16342 Rating: (2521)	Perhaps this thread (containing proper link) may help: /tf/WW/en/Posts/49558
	science guy
Suggestion To thank Quote Answer