Navigation
Simatic Automation License Manager V4.0 with SImatci Step7 V 5.4
Created by: Rajesh Shetty at: 2/9/2011 3:53 PM (3 Replies)
Rating 
Thanks 0
4 Entries
| 2/9/2011 3:53 PM | |
|
Posts: 4 Rating:
|
Hi Tom, I am facing problem with Simatic Automation License Manager V4.0 with SImatci Step7 V 5.4 To day I installed WinCC Flexible 2008. After installing WinCC flexible, when I am trying to check the licenses, it is opening to task bar but not able to maximize to view the installed licenses. Earlier also I faced similar problem while opening ALM. Error message is that ActiveX control is not available or security reasons. Can any body help, so far I didn't approach the customer support. Regards, Rajeshwar Splitted from Automation License Manager error. |
Last edited by: O_Moderator at: 2/10/2011 10:34 AMnew aubject after splitting Last edited by: Rajesh Shetty at: 2/10/2011 5:59 AMPlease find the attached error message showing snap shot |
|
| 2/10/2011 7:09 AM | |
Joined: 3/21/2006 Last visit: 1/10/2026 Posts: 10247 Rating:
|
Hello, Try with update ALM to SP5 (Entry ID: 114358.). Best regards, Hristo Mihalev |
| 2/11/2011 4:14 PM | |
|
Posts: 4 Rating:
|
Hello Hristo, Thanks you for your suggestion, but i have alreaady installed ALM V4.0, SP5 but there is no change. Regards, Rajeshwar V |
| 5/5/2011 2:20 PM | |
Joined: 9/1/2005 Last visit: 1/9/2026 Posts: 4114 Rating:
|
closed cause question posted twice. The second thread with the subject Couldn't see Licens using Automation lIcense manager V4, SP5is published within the same conference. Best regards CS Moderator |
|
My Forum is the place to personalize your profile, |
|
Follow us on