Rated X

Hello,

For this a special configrator is available to check your hardware requirements.

Please refer to following tool. SIMAITC Selection Tool
Start the APP and add your required modules and the tool will check your configuration if it is possible.

In all unclear case your Siemens sale contact will help ou to find the right solution.

I ´ve set the configuration for a ET200S station with your nice "simatic selection tool" but i am not sure with an information message that says " fifty percent of the maximum current is defined as default setting for the total current ..."
What does it mean?

I´ve 17 units of 8 DI modules
and 7 units of 8 DO mudules
and 3 units of 2 AI +-20mA
I ´ve 2 PM modules like the attachment picture.


Thansks.