SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

remote execution of Script

10/31/2012 5:33 PM	Rate (0)
plcbug Posts: 68 Rating: (0)	Dear professionals, Hope that you are doing well. I am presently working on a project for what I am finalizing system architecture, For this I have some queries I would like to share:- 1. Is it possible that I can run a script on Wincc Flex PC Runtime by pressing button over a remote HMI (KTP1000) which is connected in network. 2. Can I run a script with PLC output signal.
plcbug Posts: 68 Rating: (0)
Suggestion To thank Quote Answer

11/1/2012 10:03 AM	Rate (0)
fbelic Posts: 327 Rating: (28)	Greetings You can ran a script on OnChange event. Just make a boolean external tag, set it read continuously and adjust its event. For the first part of question, make some flag on PLC. When you press a button on panel, it changes this flag, and WinCC flex will run script on this change. Best regards
fbelic Posts: 327 Rating: (28)
Suggestion To thank Quote Answer

12/16/2012 5:39 PM	Rate (0)
plcbug Posts: 68 Rating: (0)	Hey fbelic, Can you put some more light how to set to run script on event change.
plcbug Posts: 68 Rating: (0)
Suggestion To thank Quote Answer

12/17/2012 7:49 PM	Rate (1)
fbelic Posts: 327 Rating: (28)	Greetings I though my explanation was pretty clear, but here is the explanation in picture. Best regards Attachment Change Value.jpg (337 Downloads)
fbelic Posts: 327 Rating: (28)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users plcbug

12/18/2012 4:08 PM	Rate (0)
plcbug Posts: 68 Rating: (0)	Hey fbelic, I tried it & it works but not in the way I want. It runs script at both positive & negative edge of that bool flag but I want script to run on positive edge only. Is it possible.
plcbug Posts: 68 Rating: (0)
Suggestion To thank Quote Answer

12/18/2012 6:40 PM	Rate (1)
fbelic Posts: 327 Rating: (28)	Greetings There are (at least) two ways to do this. First way is to simply add one IF...THEN at the begining of your script, comparing your boolean external flag to TRUE. Put all your code inside IF. Another way is a bit more complicated, but not much. Instead boolean, use integer variable. And instead "Change value" event, use "High Limit". Set some limit to that variable (e.g. 10). So, whenever you want to execute your script, just set it to value larger than your limit (e.g. 100). Best regards
fbelic Posts: 327 Rating: (28)
Suggestion To thank Quote Answer

Share this page:

Share this page on...