SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

s5 time value in minutes on hmi

2/23/2013 8:29 PM	Rate (0)
smileyprince Posts: 3 Rating: (0)	Dear sir, I was enable to display the S5 time BCD/BI value in minutes on my mp377,i am using wincc flexible 2008 sp3.i did scaling in tag properties and the value showing seconds,but i need show time in min How to write the timer value in step program data formate.. plz help me sir.thanks in advance.
smileyprince Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

2/24/2013 12:12 AM	Rate (0)
dchartier Grandmaster Joined: 9/27/2006 Last visit: 1/16/2026 Posts: 12481 Rating: (2722)	smileyprince Dear sir, I was enable to display the S5 time BCD/BI value in minutes on my mp377,i am using wincc flexible 2008 sp3.i did scaling in tag properties and the value showing seconds,but i need show time in min How to write the timer value in step program data formate.. plz help me sir.thanks in advance. Hello smileyprince; If you have arrived at a point where the timevalue is expressed in seconds, then you are almost done. Dividing this value by 60 would give you minutes. If you are doing the calculations in the PLC, then dividing by 60 would give you minutes and MOD by 60 would give you the remaining seconds, so you could show bothresulting valuesto create adowntimer in WinCC flexible. Hope this helps, Daniel Chartier

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users smileyprince

2/24/2013 7:11 AM	Rate (0)
umencho Grandmaster Joined: 3/21/2006 Last visit: 1/10/2026 Posts: 10247 Rating: (1183)	Just to add that FAQ here in case, for future: How do you specify the runtime for a timer via an operator panel, or how do you output the remaining runtime?

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users smileyprince

Share this page:

Share this page on...