SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Start signal for a Sinamics S150

3/12/2014 10:15 AM	Rate (0)
cemagolane Posts: 23 Rating: (0)	Hi all, This is the first time I am using a Sinamics S150. I have been looking at other posts in the forum, but I cannot find any information about which signal to use to start a Sinamics S150 from the control word. Could anyone please tell me which bit of the control word should I use to start the S150? Is it bit 0 (p840[0] ON/OFF1) or bit 3 (p852[0] Enable operation)? Thanks in advance.
cemagolane Posts: 23 Rating: (0)	Last edited by: cemagolane at: 3/12/2014 10:16 AM
Suggestion To thank Quote Answer

3/19/2014 8:14 PM	Rate (0)
zako_ Posts: 895 Rating: (67)	... for standard switch on, I prefer p852 (controlword1 bit 3). After an error and quit the axis, you have to make an 0-->1 edge on p840 (controlword bit0)
zako_ Posts: 895 Rating: (67)
Suggestion To thank Quote Answer

3/25/2014 2:47 PM	Rate (0)
cemagolane Posts: 23 Rating: (0)	Thank you very much for the information. I assume that I will still need to swap the high & low bytes of the control word to send/receive the words from the Sinamics S150?
cemagolane Posts: 23 Rating: (0)	Last edited by: cemagolane at: 3/25/2014 2:47 PM
Suggestion To thank Quote Answer

Share this page:

Share this page on...