New question published byKyaw Han Soe is split to a separate thread with the subject sinamic DCM drive show F60036.

Best regards
Min_Moderator

Ste39

Ariya Man

Ste39

Ariya Man

Marko Bursic

Do you use Vipa connectors? If the answer is yes, then tear appart the spike that is holding the cable.

When you check connectors, you usually need to redo again once you open the "scisors".

I re-check all the connections and the problem is not solved yet! Any othe sugessions?

I realized in NetPro when I click on CPUs the "active connection" section is not "OK" as shown in the attached screensho! Do you know how I can configure that?

Hello Ariya Man,
Some code of your connector? Some photo?

Hi,

Here are some screen shots attached in a "zip" folder!

Hello Ariya Man,
I said a code of your Profibus plug if it is your problem:
e.g. 6ES7972-0BA52-0XA0 (if Siemens)

Ariya Man

Ste39

Ariya Man

Ste39

Ariya Man

Marko Bursic

Do you use Vipa connectors? If the answer is yes, then tear appart the spike that is holding the cable.

When you check connectors, you usually need to redo again once you open the "scisors".

I re-check all the connections and the problem is not solved yet! Any othe sugessions?

I realized in NetPro when I click on CPUs the "active connection" section is not "OK" as shown in the attached screensho! Do you know how I can configure that?

Hello Ariya Man,
Some code of your connector? Some photo?

Hi,

Here are some screen shots attached in a "zip" folder!

Hello Ariya Man,
I said a code of your Profibus plug if it is your problem:
e.g. 6ES7972-0BA52-0XA0 (if Siemens)