SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

S7 1200 timer problem

9/13/2012 10:58 AM	Rate (0)
NeLz0n Posts: 18 Rating: (1)	Hi all, i have a problem, with the TON timer. I had a full program already compiled the program and the HW also. no problem, nowarning no error. After I change the CPU unit i had compile error with this message : ,Data type IEC_TIMER is unknown.,1,0,10:45:14 AM. I have two timer inside the SCL code, so i have these two error. After I delete the timers, and make new timers it worked also. But, then I change the cpu again, it makes the same error. I have to write a standard FB so it must to work all ofthe 1200 CPU without changeing the source code( it will be a protected code). Any idea? thx.
NeLz0n Posts: 18 Rating: (1)
Suggestion To thank Quote Answer

9/14/2012 12:04 PM	Rate (0)
Denilson Pegaia Diamond Expert Joined: 9/23/2005 Last visit: 1/9/2026 Posts: 4443 Rating: (1487)	Hi, Do you start this project in the same STEP 7 Version as do you use actually? Do you have STEP 7 V11 SP2 up4? Do you work with protect blocks?
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

9/14/2012 12:24 PM	Rate (0)
NeLz0n Posts: 18 Rating: (1)	TIA step 7 v11 sp 2. The whole project created in this version. It is not a protected block.(yet)
NeLz0n Posts: 18 Rating: (1)
Suggestion To thank Quote Answer

10/4/2012 4:19 PM	Rate (0)
miks Advanced Member Joined: 9/22/2010 Last visit: 1/8/2026 Posts: 2 Rating: (2)	I have STEP 7 V11 SP2 update4 and get this message on following way: 1. Create datatype that contains IEC_TIMER member. 2. Create empty FC in SCL that has only one InOut parameter(same hapens for In and Out)of above data type. 3. Compile FC and you wil get message: "data type IEC_TIMER is unknown" When FC is in LAD everything is OK.

Suggestion To thank Quote Answer

2/19/2015 9:47 AM	Rate (0)
Min_Moderator Posts: 4757 Rating: (122)	New question published by LB_10 is split to a separate thread with the subject S7-1200, how to use one timer. Best regards Min_Moderator
Min_Moderator Posts: 4757 Rating: (122)
Suggestion To thank Quote Answer

Share this page:

Share this page on...