Hello,

I have a problem with my temperature sensor.

I'm using 0-10V (-50 to 50°) sensor. I would like that temperature is displayd on my LOGO but all i can see now are numbers around 700. What do I have to do to see normal temperature number?

I using LOGO Soft Comfort and I don't really have much knowledge yet.

Thank you!

LoogRookie

If you query the analog input only, only the converted units will be displayed.
You need to switch after the analog input an analog amplifier, to normalize the value again.
These values represent the analog amplifier:

Sensor: 0-10V
Minimum: -500
Maximum: 500
Gain: 1.0
Offset: -500
Decimal: 1

You will then need the analog amplifier in the message text to display, and it will give you the temperature is displayed with one decimal place.

Thank you ixo65 for your help!

But could you please tell me how to setup block >Message Texts<. Beacuse I don't see text displayed in LOGO although I think I did everything like you sad to me.

I can see B001 block, but i can not see B002.

LogoRookie

Take a look at attachment.