Dear,

I am using G120 drive (PM240) with CU240E-2 (6SL3244-0BB12-1BA1) for two speed application.i.e,

pin no.-5  DI0 - Forward on command (P0840(0)-r0722.0)and reference through analog input p1000-2 is working properly.

pin no.-8  DI3 - Reverse on command (P0840(1)-r0722.3)and fixed reference P1000(0)-  -500RPM and P1020(0) - r0722.3 , But it not working.

pin no.-6  DI1 - Inch. Forward on command (P1055(0)-r0722.1) and reference  (P1058(0)- 100rpm) is working properly.

pin no.-7  DI2 - Inch. Rev. on command (P1056(0)-r0722.2) and reference  (P1059(0)-  -100rpm),But it not working.

Please send the correct parameter of C240E-2

Regards,

Binit kumar

Dear AutoGen_332109,

From your given data every time when you give reverse command you are facing problem.for that you have to set reverse set point parameters no P01113 as per your requirement.