Hello,

I am analyzing the parameters of Simovert master drive which running the induction motor on close loop seed control with encoder feed back. P100 = 4

In Vector control Compendium manual sheet 350 says that kk91 connect to parameter P222 for close loop. but actually in parameter file p222 = 0 rather than 91.

Can any one guide me that at which mode drive is running? and how it connect feed back value?

I attache drive monitor parameter file of drive and Sheet 350 diagram.

Hi

Mode of operation is CLVC with proper value in P130 as 11 or 12 depending on type of encoder

Vijay