Ashish_Akabari

Hello,

If my program is made in TIA V11. And i would like to take backup from TIA V13.

is there any solution behind that?

 S7-1200 have many issue whenever there is a TIA ver change .

The main important part is its firmware version.

If in 1200 FW>=4.0 you will be able to upload both HW/SW but if less then it then you will have to create the H/W as present and feed all the required parameter then you can only take the block upload

this is the case if from V11 to V13 and is also possible if and only if you download the upgraged V13 backupp to CPU

Ashish_Akabari

Hello,

If my program is made in TIA V11. And i would like to take backup from TIA V13.

is there any solution behind that?

 Hello Ashish,

There is no soution to Upload it with TIA V13.

You have only way to install the TIA v11 To upload that program..

Ashish_Akabari

Hello,

If my program is made in TIA V11. And i would like to take backup from TIA V13.

is there any solution behind that?

 Dera ashish,

Make hardware first then go online

press upload button and you can upload only software...!!!

New question published by 9583815919 is split to a separate thread with the subject Upload the program in TIA V11/V13.

Best regards
Min_Moderator

Hi 

it is not possible to upload program in v-13 which downloaded & created  using v-11.

the only way to upload the same is to install v-11 then copy the blocks from online access & then migrate the same project v11 to v13.

Regards

Ganesh Dighe