Hi All,

Currently connected to analog input card and discover some issue as shown in the diagnostic attachment. Field site device hasn't been connected to the Analog input card but necessary setting has been done. 

Hello,

Perhaps you can tell us, how you configured the analog card?

Best regards,

Wizard

For CH0,1 ( Measuring Range Module is B )

For CH2,3 ( Measuring Range Module is C )

For CH4,5 ( Measuring Range Module is B )

For CH6,7 ( Measuring Range Module is C )

Hello,

Is your PLC showing any SF LED? You can try removing group diagnostic from all the channels and redownload hw.

Hope this helps.

Kbv.

Hi,

Yes. The SF is lit on. Will try out your suggestion.Thanks

Hi Kbv,

if the group diagnostic is removed or untick , what will be the effect?

Hello,

I suspect because your group diagnostic is activated and channels are open, you are getting sf. Removing group diagnostic should remove error.