Hi all, is anybody actively using the recently released G-Code interpreter for Simotion?

We built a small machine around this library and application example. It works pretty well, but we have a random problem that we are not able to identify the cause and how to clear this error

From time to time at the machine power-up the interpolator block FBLGCodeInterpolator gives an error

00000001  LGCODE_IPO_ERROR_START_ DURING_RESET  Start during a reset

The block is in the in the ABORTED state and there's no way to reset this fault. I only found out the re downloading the whole simotion project sometimes seems to fix it. Probably it is clearing some internal data.

Normally the block should be in IDLE state to be able to start the G-Code processing.

Front the manual:

ABORTED:If the traversing program has been aborted by a reset, this state is active for one cycle. For an abort due to an error, the state is active until the reset input is set, followed by a switch to the IDLE state

In my case this error never resets. It also happens with the last version 3.1.2.

Thank you Christoph for taking the time to look into this.

As soon as the problem repeats i will update the thread with the info you requested.

blurp76

Thank you Christoph for taking the time to look into this.

As soon as the problem repeats i will update the thread with the info you requested.

 Dear Friend,

I get the same problems with 

FBLGCodeInterpolator gives an error

00000001  LGCODE_IPO_ERROR_START_ DURING_RESET  Start during a reset.

I can not reset it.

And I try to change the program like following:

but it does not work.

Can you give me some suggestion to fix the problems.

Thank you very much!

Dear, I make a delay on the startup as follow:

And it is not happened at the beginning of the machine power on.

Thanks!

Have a good weekend.

1. The state of the FB is not Idle, at this moment you press the start button , we will get the alarm information 0000001,and we can not clear the fault.
2. The signal gaFBNcInterpolator[x].resetActive is always on.

       And I make a try out to clear the signal of gaFBNcInterpolator[x]on the" watch table"

        (we can clear the signal in the program -------output signal)

   3. press reset , We can clear the fault, But The state is still Aborted.

"How can make change the FB state from Aborted to Idle?????"