Dear All, please i am a working with an analog sensor with the output of 0..10V.. but the analog signal board i want to use states -/+10... Please, is this range correspond to my original output from the sensor 0..10V.

Below is the attached picture..

@success

Dear All, please i am a working with an analog sensor with the output of 0..10V.. but the analog signal board i want to use states -/+10... Please, is this range correspond to my original output from the sensor 0..10V.

Below is the attached picture..

If you only want to read "part" of your Analog Input range this tutorial might help:

http://tiaportalhowto.com/en/blog/tia-portal-how-to-read-analog-inputs/

Denilson Pegaia

Hi,

there is no problem here: -10 ... + 10V is a sub set of 0 ..10V.

You can set your analogical input as -10 ... + 10V, and read 0..10V signal.

 Many thanks.. I am relaxed now. 

robert_j

 

@success

Dear All, please i am a working with an analog sensor with the output of 0..10V.. but the analog signal board i want to use states -/+10... Please, is this range correspond to my original output from the sensor 0..10V.

Below is the attached picture..

 

If you only want to read "part" of your Analog Input range this tutorial might help:

http://tiaportalhowto.com/en/blog/tia-portal-how-to-read-analog-inputs/

 Thank you robert for this useful information...