ixo65

 

ixo65

Hello mrabiudeen,

Please tell us which manufacturer and which type it is.

Or write a link to the datasheet.

 Not of the LOGO!, the manufacturer and the type of the flow meter.

Which Output is is?
Relay or transistor? If it is transistor, NPN or PNP?

 Hi

Flow meter details

Manf : Broil sensotex

Model.no: BT-PHTFS-012

Range: 50-500-5000 lph

1)Pulse output sensor;

a)Hall sensor

Power voltage: 5 to 24VDC/Low power 2 to 5Vdc

Output signal: NPN open connector output

High electric level: higher than 4.5VDC (input volt)

Low electric level: lower than 0.5VDC (input volts)

b) Read sensor

c) pick up coil: Two wire/ amplified three wire option

Regards,

M. Rabiudeen

ixo65

And what kind of output do you have?

a) hall sensor with NPN open collector output?
or
b) reed sensor?
or
c) pick up coil?

What is the pin assignment of the sensor?

 Hi

It written on flow meter body pulse 204

R.   Y .   B

+ .    P .  -

I selected I5 lsc simulation switch one time or tried with hz .R 24 vdc + ve ,P connected I5 PLC input B - ve 24 vdc supply l don't know you ask what type of output

Regards

Mrabiudeen

mrabiudeen

 

ixo65

And what kind of output do you have?

a) hall sensor with NPN open collector output?
or
b) reed sensor?
or
c) pick up coil?

What is the pin assignment of the sensor?

 Hi

It written on flow meter body pulse 204

R.   Y .   B

+ .    P .  -

I selected I5 lsc simulation switch one time or tried with hz .R 24 vdc + ve ,P connected I5 PLC input B - ve 24 vdc supply l don't know you ask what type of output

Regards

Mrabiudeen

Hi

I check with the manufacturer it's pulse output with NPN open connector hall sensor

Regards

Mrabiudeen

ixo65

Try this (see attachment).

 Hi 

Manufacturer reply if this three wire it will be hall sensor output my flow meter have three wire

 Will try your attachment please tell me about hall sensor output connection and program

Regards 

Mrabiudeen

Hi 

I tried the attachment still online test i5 always on no change in i5 signal 

Regards

Mrabiudeen

mrabiudeen

 

ixo65

Try this (see attachment).

 Hi 

Manufacturer reply if this three wire it will be hall sensor output my flow meter have three wire

 Will try your attachment please tell me about hall sensor output connection and program

Regards 

Mrabiudeen

Hi 

I tried the attachment still online test i5 always on no change in i5 signal 

Regards

Mrabiudeen

Hi

As per your attachment I tried again it's working ok.i did some messup wiring sorry for that I thanks for your support [snip]

Regards

Mrabiudeen

New question published by mrabiudeen is split to a separate thread with the subject LOGO! - exchange data with TIA Portal.

Best regards
Jen_Moderator