Hi there,

I have a problem with a HMI Panel KTP 700. For a project I have several KTP 700's and I need them to autostart after loss of power. In my eagerness I booted up the panel and immediately changed this setting so I wouldn't forget. However I did this without loading any settings/programs to the screen. Now the panel keeps rebooting before I can change the autostart function back to off, also I can't reach the screen from TIA portal because it keeps rebooting.

Is there any way to stop it from auto starting?

Thanks in advance,

Jelmer

After sending a support ticket, Siemens supplied me with the USB Recovery file. Took a while to figure out wich *.fwf file I needed since there where 3 versions in my KTP700 folder. None of them worked, I updated TIA portal while I was trying to reset the panels and after updating there was a 4th *.fwf file wich did the trick!

Thanks!