SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Double motor module

11/13/2018 8:43 AM	Rate (0)
mr.reza Posts: 94 Rating: (0)	Hello I have Sinamics s120 booksize double motor module and cu320 and two Siemens servo motor and two smc30 My question is when we connect two servomotor with double motor module is it possible to control each servo individually? I mean is it possible to start and stop just one servo? Sincerely Ataei
mr.reza Posts: 94 Rating: (0)
Suggestion To thank Quote Answer

11/13/2018 10:03 AM	Rate (0)
jacek d Platinum Member Joined: 9/23/2005 Last visit: 1/19/2026 Posts: 5155 Rating: (772)	Yes, it's possible.
	Regards, Jacek What is confusing you is the fact that you never see a number but always its digit representation. So you end up thinking that the number is the representation. - Andrej Bauer Any claims against me - based on whatever legal reason - resulting from the use of any code and/or ideas presented on this forum shall be excluded. #StayWithUkraine
Suggestion To thank Quote Answer

11/13/2018 3:09 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 1/19/2026 Posts: 6049 Rating: (828)	Hello, you need a infeed, too. 4.1 Components of the example configuration 6.1 Configuring the drive unit https://support.industry.siemens.com/cs/ww/en/view/109754314
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users jacek d

11/14/2018 1:07 PM	Rate (0)
mr.reza Posts: 94 Rating: (0)	ok but my question is about start and stop of each servo? thanks
mr.reza Posts: 94 Rating: (0)
Suggestion To thank Quote Answer

11/14/2018 2:46 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 1/19/2026 Posts: 6049 Rating: (828)	Hello Mr. Reza, yes, you can switch the two axis on and off independently from each other. You will configure each axis as individual Drive Object, therefore each axis has its own control word and status word.
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

Share this page:

Share this page on...