SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

DAC limit, no enable signal

1/31/2019 7:53 AM	Rate (0)
muha_mag Posts: 80 Rating: (1)	Hello, when I start the axis I get out of the DAC limit error. At that point I measured the signals on the drive, and I got the setpoint reference, but there is no enable signal The drive is ok, the engine is ok, the cables are ok to check it out. Numeric is a sinumerik 850. Where can there be a problem?
muha_mag Posts: 80 Rating: (1)
Suggestion To thank

2/1/2019 9:36 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8171 Rating: (174)	Closed cause question posted twice. The second thread with the subject DAC limit, no enable signal is published within the conference SINUMERIK CNC automation systems. Best regards Jen_Moderator

Suggestion To thank

Share this page:

Share this page on...