Hello,

Is it possible to transfer a program to a Simatic HMI Memory Card, then use that card to "Restore" an HMI?

Normally I would have to program the HMI, then do a "Backup". At that point I can program another HMI if needed with the card. Unfortunately, I don't have an HMI at my disposal to transfer the project to. So I need to get the project onto an HMI Memory Card so I can restore any matching screen with just the card.

Closed cause question posted twice.

The second thread with the subject WinCC Flexible Advanced Memory Card is published within the conference SIMATIC WinCC flexible.

Best regards

Jen_Moderator