Hello,

Is it possible to transfer a program to a Simatic HMI Memory Card, then use that card to "Restore" an HMI?

Normally I would have to program the HMI, then do a "Backup". At that point I can program another HMI if needed with the card. Unfortunately, I don't have an HMI at my disposal to transfer the project to. So I need to get the project onto an HMI Memory Card so I can restore any matching screen with just the card.

TP177B PN/DP-6 CSTN

6AV6642-0BA01-1AX1

That is the part number of my HMI. It has an HMI card slot on it.

And yes, the manual was the first thing I went to. I just want to make sure I am not missing anything obvious. I can restore from the SD card slot.

My question is not with the HMI, but with WinCC Flexible. Can I put a backup with my project onto an SD Card, then use that card to restore the HMI?