Hi ,

I need to migrate a project from Step 7 v5.6 which has an HMI MP377 on WinCC 2008 flexible to TIA v15.

I understand the MP377 is not compatible with TIA v15.

What will be the best solution?

Is there any HMI on WinccFlexible 2008 that I can use to replace the MP377 and than migrate the project? and after replace to another one on TIA v15...

Or maybe I have to download the software TIA professional  v14 and replace the HMI there as I understand the MP377 is compatible with the V14? 

Thansk

Dave Teodoro

Hi ,

I need to migrate a project from Step 7 v5.6 which has an HMI MP377 on WinCC 2008 flexible to TIA v15.

I understand the MP377 is not compatible with TIA v15.

What will be the best solution?

Is there any HMI on WinccFlexible 2008 that I can use to replace the MP377 and than migrate the project? and after replace to another one on TIA v15...

Or maybe I have to download the software TIA professional  v14 and replace the HMI there as I understand the MP377 is compatible with the V14? 

Thansk

 Dear Dave,

please don't post the same question twice

Sorry, 

Still a newbie... 

Wasn't sure I had posted it properly 

Won't happen again 

Closed cause question posted twice.

The second thread with the subject Migration - Which HMI is supported on Flexible and TIA? is published within the conference SIMATIC Panel.

Best regards

Jen_Moderator