SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Changing PI block settings via KTP HMI

6/5/2019 10:08 PM	Rate (0)
Luwarick Advanced Member Joined: 7/6/2017 Last visit: 9/9/2025 Posts: 53 Rating: (2)	Hi, apologies if this is in the wrong section, but I was wondering if it’s possible to change the PI settings, KC and TI, via a KTP HMI? I know I can address the parameters via VM mapping but what do I do at the HMI? I have managed to setup the weekly timer block via a hmi, by using hexadecimal for the time parameters, would I have to do the same for the PI block? Any help or examples would be much appreciated. Many thanks Rick

Suggestion To thank Quote Answer

6/6/2019 5:53 AM	Rate (1)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 1/24/2026 Posts: 36517 Rating: (4553)	Hello Luwarick, I have made you an example. LOGO! 8.FS4, LSC V8.2.1, KTP700, WinCC V13 SP2. The values are transferred to the HMI using parameter VM mapping. The only "problem" is the integration time. The value is in seconds. The LOGO! internally converts this to the display format "m: s", but the value itself is in seconds. Example: TI 2m30s. The HMI does not display 2:30, but 150 (2 x 60 + 30). Attachment PI controller settings from HMI.zip (222 Downloads)

Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users Yu-wen Tang Luwarick

6/6/2019 11:28 AM	Rate (0)
Luwarick Advanced Member Joined: 7/6/2017 Last visit: 9/9/2025 Posts: 53 Rating: (2)	Once again thank you very much

Suggestion To thank Quote Answer

6/6/2019 11:29 AM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 1/24/2026 Posts: 36517 Rating: (4553)	Hello Luwarick, your welcome.... I think, your problem is solved?
	Last edited by: ixo65 at: 06/06/2019 11:30:09
Suggestion To thank Quote Answer

Share this page:

Share this page on...