Hi all,

Sorry I have searched hi and low and cant find a simple guide as i'm new to the V20 drives. I bought myself a single phase to 3 phase 0.75Kw V20 to run my pond pump. I know these drives can do fancy things etc but i just want to set it up to run variable speeds depending on the voltage I give it. 

I have a 1212C with AO CM board to give me the 0-10v control. 

Question is what parameters need changing and to what and also what terminals my 0-10v need to be connected to as what i can see it needs a dedicated 10v supply to the drive as well. 

Once again so sorry for an awful question i don't want to mess and break anything. 

Thanks 

Have attached a diagram and hopefully a process of getting this to work.

Come back if I can help further.

tractor

Have attached a diagram and hopefully a process of getting this to work.

Come back if I can help further.

 Thank you so much, I will give it a go.

Really thank you for taking the time to help I can't thank you enough.

Excellent, this should be ok, come back if this fails to function.

Many thanks