12/5/2014 8:45 AM | |
Posts: 2 Rating: (0) |
I have problems with open DCC charts into a Sinamics DCM. After establishing connection converter with PG using STARTER we cant open DCC chart. We follow next steps: 1. create new starter project; 2. find accessible nodes via CP5711(PROFIBUS); 3. accept found drives in project; 4. load drive unit to PG (two times with and without option «Overwrite available DCC libraries») License for Starter DCC is installed, DCC is not empty. What we should do to open DCC chart? Info about installed software: Attachmentproject.zip (539 Downloads) |
9/23/2021 12:35 PM | |
Posts: 4 Rating: (0) |
As i understood, no any solutions, without engineering project, to replace Drive Unit in my case? |
9/23/2021 12:36 PM | |
Joined: 5/12/2006 Last visit: 10/22/2024 Posts: 22431 Rating: (3029)
|
correct |
This contribution was helpful to1 thankful Users |
Follow us on