Dear Experts 

i have a simotion d425 6au1425-0A00-0AA0 connected with line module and two single motor models.

it has an error. I want to check the system.  

How can I upload fault buffer.

i don’t know IP address.

i have scout 4.5.

thanking you 

Chinthana

 Dear chrishtoph

Thanking you for the advice 

i have tried with x120 and c130 with crossover cable.

no accessible nodes are recognised.

please advise 

Best Regards

chinthana

ChristophD

Hello,

connect the PC direct to one of the Thernet interfaces.

Configure the PG/PC Interface that S7Online use the connected Networkcard of the PC.

Start accessible nodes in Scout.

Then the Simotion D should be listred with the ip.

Regards

Christoph

ChristophD

Hello,

please provide some screens of the settings you use!

Is the Simotion powered up correctly?

Regards

Christoph

 Dear christoph,

thank you for the reply.

i am attaching set PCPG interface screenshot.

I have tried with both automatically obtain IP and IP of 192.168.214.15.

I have tried with Primary setup tool as well. But no node was found.

motors are running without problem for some time.

so simotion is powered correctly.

thanking you.

best regards,

chinthana.

ChristophD

Hello,

ISO is wrong because simotion doesn't support this protocol, only TCPIP.

Which state have the LED and BCD on the SIMOTION?

Can you make a screen of accessible devices with the message you get?

insteed of PST you should use PRONETA to search for SIMOTION.

Regards

Christoph

 dear mr.christoph,

I have tried with TCPIP.

motors are running for some time so SIMOTION is powered correctly. 

I am attaching a photo. please advice me.

thanking you.

best regards.

Chinthana

ChristophD

Hi,

in your last screen you use a Broadcom 802.11n adapter.

This is a WLAN adapter, but you say you have a Crossover Cable.

Do you use the wrong setting in the Interface or where you use the Crossover Cable?

Regards

Christoph

 Good day mr.christoph,

yes i have selected the wrong interface.

i have login to the device and got the error message.

i am attaching the screenshot of it.

please be kind enough to advice me repairing procedure.

best regards,

chinthana.