Dear all,

I have tried to use et 200m 153-2 as a slave for abb dcs feelance 900f.

I have adjusted bus adress and upload the gsd file. I got the fault as" paramater error on slave" . And bf led is lighting as red color.  Could you help please.

------------------------------------------------------------------------------------------
Split from IM153-2- Active bus Module.

Hello aatam;

If you were connected to a Siemens PLC as Profibus-DP master, I would recommend you open the diagnostic buffer of the CPU and the IM 153-2 to see what fault the system indicates with a red BF LED.

I am not familiar with your master ABB DCS Ffeelance 900f's diagnostic tools and capabilities. But all Profibus masters I have worked with have some kind of diagnostic structure for every slave, either a fault byte (Controllogix with Prosoft modules for Profibus, for example) or a fault detection table (Sycon configurator, for example) that will tell you more about the cause of the problem. Try to locate these tools and apply them.

When you have a better description of the fault we might be able to give you hints for what is provoking this fault on the IM 153-2.

Hope this helps,

Daniel Chartier