Hi,
I have a similar problem The drive does not throw out a single error.
When I switch to HAND mode, it does the transition, I set the speed, I press OK, the start button, the DC volts are there, but there is no sign of movement on the BOP and the engine does not start...
I looked at parameter r46, 46.0 OFF1=1, 46.8=1, 46.30=1...
I looked through STARTER, in the ramp-function generator OFF1 enable missing is orange, and in the Shutdown functions tab it is green   

------------------------------------------------------------------------------------------
Split from G120 Drive enable problem.