SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Change the parameter of the Simovert AC

3/13/2012 3:15 AM	Rate (0)
ha manh Posts: 1 Rating: (0)	Hi everyone, pls help to show me how to change the parameter of the Simovert AC 6SE7027-2ED61 by the PMU, i want to start the drive by PMU. Thankful.
ha manh Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

3/13/2012 8:06 AM	Rate (0)
umencho Diamond Expert Joined: 3/21/2006 Last visit: 3/30/2025 Posts: 10239 Rating: (1183)	Hello, Is this a brand new drive? Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

4/29/2012 11:17 PM	Rate (1)
Graeme Platinum Expert Joined: 6/4/2008 Last visit: 8/5/2025 Posts: 1518 Rating: (327)	Hi, assuming you want to permanently change the operation of your drive to operate from the PMU, then you can change P554.1 = 5 (source of the ON/OFF command). The drive will then run depending on what is connected in P443.1. If you wanted to use the UP and DOWN arrows on the PMU, then you need to make the following connections in the parameters: P443.1 = 58 (Setpoint = MOP Output) P573 = 8 (MOP UP) P574 = 9 (MOP DOWN) Hope this helps, Regards, Graeme

Suggestion To thank Quote Answer

Share this page:

Share this page on...