How to choose r0069[] in communication telegram to PLC?

MUL/DIV...etc are tried but still this parameter is not shown in signals list.

------------------------------------------------------------------------------------------
Split from Sinamics G130 and free block.

Sorry, I posted in wrong Sinamics

Ours is S120 and VC

Hello,

What type of network? Which telegram number is set in drive & PLC/controller?

Have you set CU unit & drive telegrams correctly?

r0069[0]...[7] - i.e. to transfer U phase current value, data type is Floating point 32, you need to set double word for its transmission e.g. PZD2 i.e. connect r0069[0] to p2061[2] which can be read in r2063[2].

Hope this helps.

We are Using Profibus - Free Telegram [999] 

CU320 - FW2.6

Tried to use Double Word telegram, but still r0069[] is not in the list at all, However r0068[] for example is shown!

Hello,

Are you setting drive communication or CU? Please check.

In drive communication set up, user can connect desire transmission. In attached snap PZD1 - status word 1, PZD2 - status word 2 & PZD3 - r0069[0]. 

Actually, our communication is only via MM object and CU is not used for that.

I tried offline to configure same as you did "check attached", CU telegram still not show this r69, however r68 is accepted either in MM or in CU.

Is it FW related, I mean in this old FW Siemes was not allowing to monitor this parameters?

System is not allowing to attach RAR files

Hello,

I suggest you to raise support request here. I checked up to v2.6 & found r0069 is available. I do not know/check about your present MM version, i.e 2.50.32.35.

Hope this helps.

P. S. - Please do not forget to share reply here, which you receive from Siemens .