Hi.

I am new to this controller so bear with me 

Controller is hooked up to a pool pump. I start it with hand mode and it runs fine.

Now I want to be sure that it starts automatically if there is a power outage.

What do I neee to do in terms of programming and wiring?

Many thanks 

Maybe this thread will help: V20 run on startup - 279561 - Industry Support Siemens

Or this one: sinamics v20 after power-out - 123528 - Industry Support Siemens

U_7d8627bb-e469-433e-bbb3-f944d2cc85c3

Hi.

I am new to this controller so bear with me 

Controller is hooked up to a pool pump. I start it with hand mode and it runs fine.

Now I want to be sure that it starts automatically if there is a power outage.

What do I neee to do in terms of programming and wiring?

Many thanks