SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

red light of module

8/17/2010 3:52 PM	Rate (0)
gkhn__ Posts: 27 Rating: (0)	ı use am2 pt 100 module first time , do we need to additional thing for communication with logo or just connect them in the rack is enough. and red lightshining is that mean am2 pt 100 module is run or do we need green light.
gkhn__ Posts: 27 Rating: (0)
Suggestion To thank Quote Answer

8/18/2010 8:28 AM	Rate (0)
ring24h Posts: 719 Rating: (62)	Hello gkhn__ you need green light. I think the connection on the right Side of the Logo or the left Side of AM2 is not correct? MfG. ring24h
ring24h Posts: 719 Rating: (62)
Suggestion To thank Quote Answer

8/19/2010 1:57 PM	Rate (0)
LOGO!Barbarian Posts: 173 Rating: (95)	Hi gkhn___!! (again!) You get a RED light on an expansion module if it is not communicating with the LOGO! or expansion module on the left side of it. So do/check the following.... 1) make sure that the communication bus SLIDER (grey) has been pressed down with a flat screwdriver about 1mm and slid over to the left into the LOGO! or other expansion module. (You will have to use a small flat screwdriver to remove the cover on the right side of the LOGO! or expansion module to be able to do this. It is shown very nicely in the manual) 2) The grey communication bus slider must move completely over to the left before releasing it. When it springs back up (1mm), then a small 'hook' catches into the LOGO! next to it. This is what keeps it secure. OR An expansion module MUST get power BEFORE the LOGO! OR at tzhe SAME time. If an expansion module is connected to another power supply, then it will come with a red light if the communication to the LGO!O on the left does not start correctly. Hope this helps too! Aaaaarrrggghh!!!! ("have a nice day!")
LOGO!Barbarian Posts: 173 Rating: (95)
Suggestion To thank Quote Answer

8/19/2010 2:30 PM	Rate (0)
gkhn__ Posts: 27 Rating: (0)	you are absolutely right ı disconnected the am2 module and connect again tightly and everything get well afterI try 2 hours.
gkhn__ Posts: 27 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...