SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Shopmill Enable in 840DI system in PCU50

7/11/2007 6:23 AM	Rate (0)
prabhat Posts: 2 Rating: (0)	Dear Sir, I have new system of 840Di .I have already loaded all the initial software.and Shopmill through pen drive.But after starting HMI start up it is showing Shopmill is not enable .How can i enable the Shop Mill.
prabhat Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

7/11/2007 8:41 AM	Rate (0)
Drxxx Advanced Member Joined: 4/20/2007 Last visit: 6/20/2025 Posts: 11 Rating: (1)	Dear Sir, You need to download Plc program into sytem as well.Please check from documentation. Regards

Suggestion To thank Quote Answer

7/11/2007 8:55 AM	Rate (0)
prabhat Posts: 2 Rating: (0)	Dear Sir, I have already downloaded all the FC and DB which are required for Shopmill according to pdf file in DONCON CD.Still it is showing ShopMill not enable
prabhat Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

7/12/2007 9:28 AM	Rate (0)
poziomka Posts: 17 Rating: (2)	Dear Sir, Please check if the PLC is in the RUN state, also please check if the version of ShopMill fulfill requirement of the compatibility list for ShopMill and 840Di.
poziomka Posts: 17 Rating: (2)
Suggestion To thank Quote Answer

1/12/2008 5:10 AM	Rate (0)
CNCX Posts: 9 Rating: (0)	Hello, I am encountering the same problem. how did you solve the problem. Thaks.
CNCX Posts: 9 Rating: (0)
Suggestion To thank Quote Answer

1/15/2008 8:23 AM	Rate (0)
taerojjang Regular Member Joined: 8/29/2007 Last visit: 6/26/2014 Posts: 27 Rating: (0)	Before I also had experience about that problem. If you modify OB1 block in PLC. you can solve that problem. you canrefer Doc on CD "Description of Functions ShopMill" chapter 5.6 you can solve problem ~ good luck. ^^

Suggestion To thank Quote Answer

1/15/2008 9:27 AM	Rate (0)
CNCX Posts: 9 Rating: (0)	Thank you. I will give it a try.
CNCX Posts: 9 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...