SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Simoreg DC-Master 6RA7000, fault - F063

4/25/2017 12:27 AM	Rate (0)
AlexSevas Posts: 5 Rating: (0)	Hello, I have on board Simoreg DC-Master 6RA7000-0MV62-0-Z, When I want to start Z-Drive it has fault: F063 and not work cooling blower for DCM Can you please assist me to fix this problem, I think it is problem in el. board A7001(X163). Thanks.
AlexSevas Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

4/25/2017 5:13 AM	Rate (0)
KSN Diamond Expert Joined: 8/25/2006 Last visit: 1/15/2026 Posts: 2221 Rating: (282)	Hello. Yes, you are right. The possible causes are defective boards A7001/A7006/A7041/A7042. Check the fault value in r949.

Suggestion To thank Quote Answer

4/25/2017 8:40 AM	Rate (0)
AlexSevas Posts: 5 Rating: (0)	Thanks for answer. Can you please give me some picture, where is situated this cards? And also where I can see Fault value r949? TYVM.
AlexSevas Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

4/25/2017 8:57 AM	Rate (0)
KSN Diamond Expert Joined: 8/25/2006 Last visit: 1/15/2026 Posts: 2221 Rating: (282)	You can find the placement of boards in the manual, page 6-48. Parameter r949 contains fault value.

Suggestion To thank Quote Answer

4/25/2017 10:21 AM	Rate (0)
AlexSevas Posts: 5 Rating: (0)	So, after restar of fault, I have anather fault, o12.4, I check it in manual, it is A7042 board, that is correct? And if I replace this card, by new one, it is necessary input parameters?
AlexSevas Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

4/25/2017 10:24 AM	Rate (0)
AlexSevas Posts: 5 Rating: (0)	*another
AlexSevas Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

4/25/2017 10:50 AM	Rate (0)
KSN Diamond Expert Joined: 8/25/2006 Last visit: 1/15/2026 Posts: 2221 Rating: (282)	After replacement of this card you need not to restore parameters.

Suggestion To thank Quote Answer

4/25/2017 6:49 PM	Rate (0)
AlexSevas Posts: 5 Rating: (0)	Thanks a lot! I install new one, and all working properly. Best Regards.
AlexSevas Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...